For PCB designs carrying around 200 A continuous, what are the practical options for integrating bus bars? Can bus bars be assembled onto the PCB, or is mechanical fastening (screws/bolts) generally preferred over soldering? Are heavy-copper PCBs or locally reinforced copper a viable lower-cost alternative?
Most PCB manufacturers will consider custom busbar requirements, although they may charge extra depending on the design and assembly process.
Heavy-copper PCBs are another option, and some manufacturers offer designs with embedded busbars so the extra copper is used only where needed. However, these specialized boards can also be expensive.
Soldering a busbar directly to the PCB can be challenging because its thermal mass draws heat away from the joint. I’d check with the assembler before committing to that approach.
For 200 A continuous current, I’d compare a separate bolted busbar with heavy-copper and embedded-busbar PCBs. Whichever option you choose, pay close attention to resistance at the joints and connections. Bolted connections need sufficient contact area, suitable surface finishes, and controlled fastening to maintain low resistance.
One thing to consider is mechanical support. At 200 A, don’t let the busbar’s weight or vibration load the PCB solder joints. Use suitable standoffs or brackets to support it independently, and allow for thermal expansion. I’d also test the assembled board at full continuous current and check the temperature at the joints, since they can become hotter than the busbar itself.
One detail I’d check is how current transfers from the busbar into the PCB copper. Even if the busbar handles 200 A comfortably, narrow copper necks or an undersized via array can create localized heating. Keep the transition broad and verify that any vias or parallel copper paths can safely carry their share of the current.
One additional consideration is the prospective short-circuit current, not just the 200 A continuous rating. A fault can produce much higher current and significant mechanical forces in the busbar before protection trips. I’d size and support the busbar for the expected fault current and protection clearing time, in addition to checking its continuous-current temperature rise.
Another option worth considering is purpose-designed high-current press-fit power terminals. These are available for PCB-to-busbar connections, with some product families rated for currents up to 500 A. However, the actual current capacity depends on the complete assembly, not just the terminal rating.
Make sure to follow the manufacturer’s requirements for finished-hole diameter, plating thickness, PCB thickness, and surface finish. These are important for achieving a reliable press-fit connection.