SPOT THE FLAW: Some connections are getting a little too friendly

lucy.sierracircuits · November 3, 2026, 5:50pm

Answer on Friday…

timothy.phillips · November 3, 2026, 7:43pm

Clearance between tracks too small for fabrication.

Topic		Replies	Views
SPOT THE FLAW: Sometimes, the problem is the neighborhood PCB Design Challenges	1	62	September 4, 2026
SPOT THE FLAW: Something important may have lost its way back PCB Design Challenges	1	51	October 9, 2026
SPOT THE FLAW: Two paths, two very different jobs PCB Design Challenges	1	53	October 16, 2026
SPOT THE FLAW: This design may look fine before the heat is on PCB Design Challenges	1	124	September 11, 2026
SPOT THE FLAW: Something was left unfinished PCB Design Challenges	1	70	August 21, 2026